10 x 16 Pin Replacement Cartridges for A6S Ultima Microneedling Pen
10 x 16 Pin Replacement Cartridges for A6S Ultima Microneedling Pen
🏷 Black Friday Sale 🏷
Enjoy 20% OFF Storewide • FREE GIFT WITH $200+ PURCHASE • From 14 November - 02 December • Use Code: BLACK20 • T&Cs Apply
*T&Cs apply: Valid for drpen.com.au only until 02/12/2024 11:59pm AWST. Must use code at checkout. Offer excludes bundles. Limit to one code per customer. Cannot be used in conjunction with any other offer. Whilst stocks last. Dr. Pen Global reserves the right to amend any promotional offer.
Complete your journey to healthier skin with:
Get the full routine and speed up your results
USED IN SALONS
Trusted by professionals
FREE AUS SHIPPING
Over $99.00
What's Included:
- 10 pack of 16-Pin needle Dr. Pen cartridges, compatible with the A6S Microneedling Pen.
Please note: Ensure to use a new needle cartridge each time you microneedle.
Important: Microneedling cartridges must be sterilised before each use to ensure the treatment is safe and hygienic. It is essential to follow these steps carefully to ensure that the microneedling cartridges are properly sterilised. Here are the steps to sterilise microneedling cartridges:
- First, ensure that you have all the necessary equipment for sterilisation; gloves, isopropyl alcohol solution (70% or above) and a clean container to hold the solution.
- Put on your gloves to avoid contaminating the cartridges during the sterilisation process.
- Check on your cartridge; ensure the needles are in perfect condition (i.e. not bending) and remove any debris.
- Pour enough alcohol solution into the container and dip the cartridge needle into a sterilisation container, then soak for a couple of minutes.
- If you have alcohol solution in a spray model, you can spray it towards the needle head of the cartridge.
- Once the sterilisation is complete, allow the cartridge to air dry before using it.
- Finally, your cartridge is ready for use.
How to Use
- To ensure there is no cross-contamination, cartridges must be sterilised before treatment.
- Double-cleanse (cleanse and repeat) then wipe the skin clean. Fully tie back your hair, away from your face.
- Work in small areas and apply serum to each area before needling. This will help to ensure that the pen does not drag or pull on the skin. The recommended pattern to move the pen for best results is vertical, horizontal, and then diagonal in both directions. Using a light pressure and without dragging, repeat this motion over each area two times.
DO NOT USE
- On open wounds.
- On active acne or irritated skin.
- If irritation occurs.
- 16-pin cartridges are not suitable for hair loss
Use up to a maximum of 1mm. Refer to the Dr. Pen Needle Depth Guide. Please speak with your doctor before purchasing any Dr Pen products. The content on this site is not intended to substitute for the advice of a qualified physician, pharmacist, or other licensed health-care professional. The products may have additional information and instructions on or inside the packaging that you should carefully read and follow. Contact your health-care provider immediately if you suspect that you have a medical problem. This product may not have been evaluated by the Food and Drug Administration and is not intended to diagnose, treat, cure, or prevent any disease or health condition. For any concerns or questions, please contact your GP or dermatologist.